Pioneer DEH-P7150UB - Manual (Page 35)

35
O
D
R & Pu
re Co
m
p
o
n
e
n
t Sy
s
t
e
m
s
RS-A9
SHARC® DSP chip
RS-A9
Digital Integrated Power Amplifier
600 W Max. Limited distribution
RS-A7
Digital Power Amplifier
600 W Max. Limited distribution
• 50 W × 4 (4 Ω)/75 W × 4 (2 Ω)/50 W × 2 + 150 W
× 1 (4 Ω)/150 W × 2 (4 Ω) (continuous power)
• 100 W × 4 (4 Ω)/100 W × 2 + 300 W × 1 (4 Ω)/
300 W × 2 (4 Ω) (max. power)
• High-performance 32-bit floating binary point
type DSP
• Built-in DSP (Digital Signal Processor) (FIR)
—31-band L/R independent digital
graphic equalizer (±12 dB/0.5 dB steps)
—3-band L/R independent digital parametric
equalizer (±12 dB/0.5 dB steps)
—5-mode preset memory
—Time alignment
—Digital listening position selector
—Parametric bass/treble controls
—Digital compression
—4-way L/R independent digital crossover
network (high/mid/low/subwoofer) —Crossover frequency:
20 Hz to 20,000 Hz (variable)
—Crossover slope: 0 dB
to –72 dB
• 1 optical digital input
• 3 optical digital outputs
(mid/low/subwoofer)
• 50 W × 4 (4 Ω)/75 W × 4 (2 Ω)/50 W × 2 +
150 W × 1 (4 Ω)/150 W × 2 (4 Ω)
(continuous power)
• 100 W × 4 (4 Ω)/100 W × 2 + 300 W × 1 (4 Ω)/
300 W × 2 (4 Ω) (max. power)
• 2 optical digital inputs
Caution: To avoid damaging your amplifier/subwoofer system, please make sure that the continuous power output of the amplifier is lower than the nominal power handling of the subwoofer.
Common Features
• Bridgeable 4/3/2-channel capability
• Current feedback amplifier
• Full balanced system (bridgeable
connection)
• Multi 24-bit Burr Brown D/A converters
• IP-Bus input/output
• Gold-plated screw-type speaker terminals
• Gold-plated large screw-type power/
ground terminals
• Low load impedance capability
(4 Ω, 2 Ω to 8 Ω allowable)
• Copper-plated chassis
• L/R independent power supply
• Sound master clock
• DAC volume
The TS-W01RSII’s magnetic circuit structure uses a voice coil with large ø140 mm
diameter to drive the center part of the entire speaker cone to improve transient.
Multiple neodymium magnets creating powerful
magnetic flux help drive the cone with exceptional
strength and accuracy.
The large vent in the center of the speaker back is
maximized for fine control to reduce air resistance.
The result: more accurate bass reproduction.
Compact Enclosure
We design our subwoofer cones for compact (14 to 28 liters) speaker enclosures.
Shallow mounting aluminum
die-cast basket and large
ø140 mm voice coil
Large ø140 mm Voice Coil
TS-W01RSII
• 3.5 cm tweeter with ion-plated DLC (Diamond-like Carbon)-coated dual arc ring diaphragm
• High-performance magnetic circuit features lightweight aluminum
voice coil with neodymium magnet
• Zinc die-cast frame
• Tungsten cone holder with anti-resonance structure
• Aluminum die-cast mounting bracket included
• Gold-plated large screw-type terminals
• Use with UD-N01RSII 2-Way Passive Crossover Network
• Maximum input: 120 W
• Nominal input: 50 W
TS-T01RSII
3.5 cm Component Tweeter
• 17 cm cone mid-bass speaker with multiple pulp fiber composite diaphragm
• Ion-plated DLC (Diamond-like Carbon)-coated titanium center cap
• Corrugated surround with damped coating on front
and back edges
• High-Transient Short Voice magnetic circuit features
copper ribbon short voice coil with neodymium magnet
• Bottom hold design zinc die-cast one-piece chassis
• Tungsten damper holder with anti-resonance structure
• Gold-plated large screw-type terminals
• Use with UD-N01RSII 2-Way Passive Crossover Network
• Maximum input: 120 W
• Nominal input: 50 W
TS-M01RSII
17 cm Component Mid-Bass Speaker
• 7.7 cm cone midrange speaker with multiple pulp fiber
composite diaphragm
• Ion-plated DLC (Diamond-like Carbon)-coated titanium
center cap
• Corrugated surround with damped coating on
front and back edges
• High-Transient Short Voice magnetic circuit
features copper ribbon short voice coil with
neodymium magnet
• Bottom hold design zinc die-cast one-piece chassis
• Tungsten damper holder with anti-resonance
structure
• Zinc die-cast back basket
• Gold-plated large screw-type terminals
• Maximum input: 50 W*/60 W**
• Nominal input: 15 W
TS-S01RSII
7.7 cm Component Midrange Speaker
* With speaker unit only
** With back chamber
• 25 cm cone woofer with multiple pulp fiber composite
diaphragm and integrated center cap
• Space-saving small-enclosure-type design
(recommended enclosure:
14 l to 28 l/0.49 cu.ft. to 0.99 cu.ft.)
• Corrugated fiber surround with damped
coating on front and back edges
• Large-sized ø140 mm voice coil
with multiple neodymium magnets
• Shallow mounting aluminum
die-cast basket
• Gold-plated large screw-type terminals
• Maximum input: 300 W
• Nominal input: 150 W
TS-W01RSII
25 cm (10") Component Subwoofer
• Use with TS-M01RSII and TS-T01RSII
UD-N01RSII
2-Way Passive Crossover Network
120 W Max. 50 W*/60 W** Max.
300 W Max.
120 W Max.
Ion-plated DLC (Diamond-like Carbon)-coated titanium center cap is superior in
rigidity, and concave to suppress resonance in the magnetic circuit.
High-Transient Short Voice magnetic circuit achieves excellent sound linearity from
high to mid-range and features a high number of turns of wire in the short lightweight
voice coil (for voice coil drivability that is 15 % better than its predecessor).
Corrugated surround with damped coating on
front and back edge effectively absorbs unwanted
vibration, achieves excellent linearity and reduces
interference of cone and surround.
High-Quality Mid-Bass Speaker
TS-M01RSII
Corrugated surround
The TS-T01RSII’s Dual Arc Ring Diaphragm, based on Pioneer’s
Super Wide Range Tune innovation, reliably reproduces clear
sound audible up to super-high 48 kHz frequency.
The inside and outside of the center drive-type ring
diaphragm are shaped differently from each other, and
vibrate to varying degrees for various frequencies. These
frequencies are mixed to achieve smooth characteristics
for superior sound reproduction. The light diaphragm has
a surface that is ion-plated with DLC (Diamond-like Carbon)
coating for extra rigidity and minimal distortion. 35 mm in
diameter, the diaphragm also contributes to excellent low
frequency reproduction and precise, accurate sound staging.
Dual arc ring diaphragm
TS-T01RSII
Dual Arc Ring Tweeter Diaphragm