Panasonic KX-TG2356 - Manual (Page 68)

68
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on
Your Display...” (p. 67) for the Cause & Remedy.
Telephone System
Problem Cause & Remedy
“No link to base. Move
closer to base, try
again.” is displayed and an
alarm tone sounds. • You are too far from the base unit. Walk
closer to the base unit.
• Confirm the base unit’s AC adaptor is
plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 51).
Static, sound cuts in/out,
fades. Interference from other
electrical units. • Move the handset and base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
The handset and/or base unit
does not ring. • The ringer volume is turned off. Set to high,
medium, or low (p. 17, 18).
The handset display is blank. • If the only handset display is blank, fully
charge the battery (p. 10).
You cannot program any
function items. • Programming is not possible while the
handset and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• While another user is listening to messages
or the Answering System is handling a call,
you cannot program. Try again later.
While programming or
searching, the handset starts
to ring and the program/
search stops. • A call is coming in. To answer the call, press
[C], [s] or [SP-PHONE]. Start again from
the beginning after hanging up.
You cannot make an intercom/
outside call. • Your handset is in remote operation mode
(p. 55). Exit by pressing [OFF].
• The handset you called is too far from the
base unit.
• If the handset or base unit is in use, you may
not be able to make a call. Try again later.
PQQX13988YA.book 68 ページ ２００４年２月５日 木曜日 午前１０時５分