Troubleshooting, Engine stops or loses power engine overheating – Polaris Hawkeye 2x4 User Manual
Page 113

111
TROUBLESHOOTING
Engine Stops or Loses Power
Engine Overheating
Possible Cause
Solution
Out of fuel
Refuel, cycle key to ON position three
times for 5 seconds each, then start
Kinked or plugged fuel vent line
Inspect and replace (if equipped)
Water is present in fuel
Replace with fresh recommended fuel
Old or non-recommended fuel
Replace with fresh recommended fuel
Overuse of choke
Inspect, clean and/or replace spark plugs
Fouled or defective spark plug(s)
Inspect, clean and/or replace spark
plug(s)
Worn or defective spark plug wires
See your dealer
Incorrect spark plug gap or heat range
Set gap to specs or replace plug
Loose ignition connections
Check all connections and tighten
Low battery voltage
Recharge the battery to 12.8 VDC
Clogged air filter
Inspect and clean or replace
Reverse speed limiter malfunction
See your dealer
Electronic throttle control malfunction
See your dealer
Other mechanical failure
See your dealer
Overheated engine
Clean engine exterior, see your Polaris
dealer
Possible Cause
Solution
Towing/dragging heavy loads
Install the accessory oil cooler if the
vehicle will be used for towing heavy
loads, dragging ground surfaces or
performing similar activities.
Operating in excessive heat
Install the accessory oil cooler if the
vehicle is normally operated when the air
temperature is above 38
° C.