Philips SPA7210/17 - Manual (Page 4)

EN
Multimedia Speakers
Warning : 1. The product shall not be exposed to dripping or splashing
and that no objects fi lled with liquids, such as vases, shall be placed on
the product. 2. To completely disconnect the power input, the mains
plug of the product shall be disconnected from the mains. 3. The mains
plug of the product should not be obstructed OR should be easily
accessed during intended use. 4. No naked fl ame sources, such as
lighted candles, should be placed on the products.
Note : 1. Ensure that the multimedia speaker is installed properly before
using. 2. The maximum output voltage of headphone jack is equal or less
than 150mV. 3. The USB socket is for charging 5V devices only.
Installation:
1
Connect the audio cable to the audio output of your computer (Fig.
1).
2
Adjust the length of speaker cable by the cable winder at the bottom
of the left speaker (Fig. 2).
3
Connect the power cable to the power adaptor (Fig. 3).
4
Connect the power adaptor cable to the 12V DC socket at the back
of the right speaker and a AC power socket (Fig. 4).
5
Turn the volume knob clockwise to switch on the Multimedia
Speakers (Fig. 5).
The indicator on the right speaker lights up. »
6
Adjust the volume either by the volume knob or by the computer
application or multimedia application software (Fig. 6).
To listen through a headphone, connect it to the
•
socket on the
right speaker.
To play sound from a MP3, connect it to the
•
AUX IN socket on
the right speaker.
The USB socket on the right speaker can be used to recharge a
•
USB rechargeable device (e.g. MP3, mobile phone, ect.) (Fig. 7).