Philips Integrated Circuits PDIUSBH12 - Manual (Page 7)

Philips Semiconductors Product specification
PDIUSBH12 USB 2-port hub
1999 Jul 22 7
Pin description (MODE 0 – Good Link

)
PIN NO. PIN SYMBOL TYPE DRIVE DESCRIPTION
1 TEST1 Input
Connect to Ground for 48MHz crystal input.
Connect to V
CC
for 12MHz crystal input.
2 TEST2 Input Connect to Ground
3 TEST3 Input Connect to Ground
4 RESET_N Input ST Power-on reset
5 GND Power Ground reference
6 XTAL1 Input Crystal connection 1 (48 or 12MHz depending on TEST1 pin)
7 XTAL2 Output Crystal connection 2 (48 or 12MHz depending on TEST1 pin)
8 CLKOUT Output 3mA Programmable output clock for external devices
9 V
CC
Power Voltage supply 3.3V
±
0.3V
10 OCURRENT_N Input ST
Over-current notice to the device. This pin is also used to sense the USB VBUS.
A LOW on this pin of less than 2 seconds is interpreted as an overcurrent notice;
longer than 2 seconds is interpreted as loss of VBUS.
11 SWITCH_N Output OD6 Enables power to downstream ports
12 SUSPEND Output OD6 Device is in suspended state
13 DN2_GL_N Output OD6 Downstream port 2 GoodLink

LED indicator
14 DN3_GL_N Output OD6 Downstream port 3 GoodLink

LED indicator
15 RSVD Input Reserved. Connect to GND for normal operation.
16 RSVD Input Reserved. Connect to GND for normal operation.
17 INT_N Output OD6 Connect to microcontroller interrupt
18 SDA I/O OD6 I 2 C bi-directional data
19 SCL I/O OD6 I 2 C bit-clock
20 GND Power Ground reference
21 DN3_DP AI/O Downstream port 3 D + connection
22 DN3_DM AI/O Downstream port 3 D – connection
23 DN2_DP AI/O Downstream port 2 D + connection
24 DN2_DM AI/O Downstream port 2 D - connection
25 AGND Power Analog Ground reference
26 AV
CC
Power Analog voltage supply 3.3V ± 0.3V
27 UP_DP AI/O Upstream D + connection
28 UP_DM AI/O Upstream D - connection
NOTE:
1. Signals ending in _N indicate active low signals.
ST: Schmitt Trigger
OD6: Open Drain with 6 mA drive
AI/O: Analog I/O