Premier Mounts POLARIS MAG - Manual (Page 7)

MAG
Installation Manual Page - 7 -
Adjusting the Projector
After the projector has been installed, the projector must then be
adjusted. To adjust the projector:
1. Loosen the M5 set screw using the M5 Allen wrench (both
sides).
2. Adjust the projector to the correct position. Firmly grasp the
projector in both hands, and tilt either forward or backward
to adjust the level.
-OR-
Firmly grasp the projector in both hands and rotate side to
side for orientation adjustment.
3. Tighten both M5 set screws using the M5 Allen wrench.
Troubleshooting Procedures
QUESTION: My projector mount must be set at an angle to be viewed properly on the ceiling, but the
projector will not hold at this position. Why is this?
ANSWER: The angle adjustments are not tight; they must be tightened.
QUESTION: What happens if the universal legs don’t fit my projector?
ANSWER: Contact Customer Service and advise them of the situation.
Technical Specifications
All measurements are inches (mm).
M5 Set Screw
M4 x 12mm Security
Screw and Star Washer