Premier Mounts POLARIS MAG - Manual (Page 5)

MAG
Installation Manual Page - 5 -
Attaching the Mount
Unpack the MAG Mount and review any WARNING statements that apply to the installation. Select the desired
location for the MAG Mount.
1. Locate the mounting points on the bottom of the projector
(see arrows above for mounting point recognition).
NOTE: Projector mounting points will vary. The projector
used in this manual is an example, and may not match
yours exactly.
2. Attach the appropriate number of mounting legs to the
projector using the appropriate mounting hardware
(see Page 4, Selecting the Proper Mounting Hardware).
3. Do not tighten these screws completely at this time.
4. Align the projector plate to the mounting legs.
5. Position the legs accordingly for best configuration. You
may raise or lower each leg independently by turning the
leveling barrels.
6. Secure the legs to the projector plate by screwing
M6 x 12mm security screws into the M6 square nut (do not
overtighten) on the mounting legs.
7. Tighten all security screws at this time.
8. Once the security screws have been tightened, place the
plastic cap over each leveling barrel and firmly push the
plastic cap into place.
Single Mounting Point Installation
If your projector has a ¼-20 x 5/16” mounting point, please refer
to the following three steps:
1. Determine where the mounting point is located. 2. Place the projector plate over the mounting point.
3. Insert the ¼-20 x 5/16” security screw.
NOTE: This screw will use a standard hole when mounting.
¼-20 x 5/16” Mounting
Screw
Mounting Point
Standard Hole