Philips 8040X - Manual (Page 12)

ENGLISH
3 Press the on/off button with your other
hand.
4 Hold both buttons for a few seconds until
razor makes a brief humming sound and
the top charging light blinks a few times.
The razor is now ready for use again.
B
The razor unlocks automatically when you place
the razor in the charging stand while plugged in.
Checking if the razor is locked
properly
1 Press the on/off button briefly (less than
3 seconds).
2 The charging light blinks green to confirm
that the travel lock is active.
Cleaning
◗ Always clean your razor after each use.
◗ Regular cleaning guarantees better shaving
results.
◗ Never remove or replace Razor Head
Assembly while motor is on.
◗ Do not apply pressure to combs. Do not
touch razor heads with hard objects as this
may dent or damage precision-made slotted
combs.
22 ENGLISH
◗ Do not use razor if combs are damaged or
broken. Facial injury may occur.
◗ Never dry the shaving unit with a towel or
tissue as this may damage razor heads.
◗ Do not use abrasives, scourers or liquids such
as acetone to clean the appliances.
Razor Head Assembly: After Each Use
◗ It is recommended that you clean the Razor
Head Assembly thoroughly after each use to
maintain optimal shaving performance.
1 Press the on/off button to turn razor ON.
C
2 Rinse Razor Head Assembly under hot
tap water by letting the water run in and
around all the openings for at least 30
seconds.
C
3 You can also immerse Razor Head
Assembly in hot water for at least 30
seconds.
Make sure razor is ON to thoroughly remove any
residue.
BE CAREFUL TO TEST WATER FIRST SO AS
NOT TO BURN OR SCALD HANDS.
4 Turn razor OFF and shake off excess
water.
23