Pioneer VSX-1017AV-K - Manual (Page 49)

Other connections 09
49
En
1 Connect your speakers as shown below.
This illustration below shows the connections for bi-
amping your front left speaker. Hook up your front right
speaker in the same way.
Since both front and surround back speaker terminals
output the same audio, it doesn’t matter which set (front
or surround back) is powering which part (
High or Low)
of the speaker.
• Make sure that the + / – connections are properly
inserted.
2 Select the ‘Front Bi-Amp’ setting from the ‘Surr Back
System’ menu.
See
Surround back speaker setting on page 38 to specify
how you’re using the surround back speaker terminals.
Caution
• Most speakers with both High and Low terminals
have two metal plates that connect the High to the
Low terminals. These must be removed when you are
bi-amping the speakers or you could severely
damage the amplifier. See your speaker manual for
more information.
• If your speakers have a removable crossover network,
make sure you do not remove it for bi-amping. Doing
so may damage your speakers.
Bi-wiring your speakers
The reasons for bi-wiring are basically the same as bi-
amping, but additionally, interference effects within the
wire could be reduced, producing better sound. Again, to
do this your speakers must be bi-wireable (that is they
must have separate terminals for the high and low
frequencies). When bi-wiring, make sure you’ve selected
Normal (SB) or Speaker B in Surround back speaker
setting on page 38.
• To bi-wire a speaker, connect two speaker cords to
the speaker terminal on the receiver.
Caution
• Make sure you use a parallel (not series, which are
fairly uncommon) connection when bi-wiring your
speakers.
• Don’t connect different speakers from the same
terminal in this way.
Connecting additional amplifiers
This receiver has more than enough power for any home
use, but it’s possible to add additional amplifiers to every
channel of your system using the pre-outs. Make the
connections shown below to add amplifiers to power
your speakers.
• Before making or changing the connections, switch
off the power and disconnect the power cord from the
AC outlet.
• You can use the additional amplifier on the surround
back channel pre-outs for a single speaker as well. In
this case plug the amplifier into the left (
L (Single))
terminal only.
• The sound from the surround back terminals will
depend on how you have configured the Surround
back speaker setting on page 38.
• To hear sound only from the pre-outs, switch the
speaker system to OFF, or simply disconnect any
speakers that are connected directly to the receiver.
• If you’re not using a subwoofer, change the front
speaker setting (see Speaker Setting on page 43) to
LARGE.
SPEAKERS
A B R L R L R L ( Single)
FRONT CENTER SURROUND SURROUND BACK /
SELECTABLE SEE INSTRUCTION MANUAL
High
Low
Front left
speaker
VSX-1017AV
(Single)
IN OUT
IN MONITOR
OUT OUT
DVR/VCR2
AM LOOP PRE OUT
OUT
IN
3
R
R R
R
R R
L L
L L L
L CENTER
CENTER
MULTI CH IN
FRONT
FRONT
SUR-
ROUND
SUR-
ROUND SURROUND
BACK
SURROUND
BACK SUB
WOOFER
SUB
WOOFER
INPUT
L R
ANALOG
Front channel
amplifier
INPUT
L R
ANALOG
Surround channel
amplifier
INPUT
L R
ANALOG
Surround back
channel amplifier
INPUT
ANALOG
Powered
subwoofer
INPUT
ANALOG
Center channel
amplifier (mono)
VSX-1017_HY.book Page 49 Tuesday, March 6, 2007 3:53 PM