Philips E5000 - Manual (Page 8)

Place the handle in the plugged-in charger.
3 To deactivate the Easy-start feature, press and hold the on/off button
for 5 seconds. You hear 1 beep to indicate that the Easy-start feature
has been deactivated.
4 To activate the Easy-start feature, press and hold the on/off button
for 5 seconds. You hear beeps to indicate that the Easy-start
feature has been activated.
Use of the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces the effectiveness of the Sonicare toothbrush
in removing plaque.
Make sure the Easy-start feature is deactivated and the handle fully
charged when the Sonicare is used in clinical trials.
Smartimer
The Smartimer automatically sets the brushing time to the minutes
that dentists and dental hygienists recommend.
After minutes, the Smartimer automatically switches off the
toothbrush.
If you want to stop brushing briefly during a 2-minute brushing cycle,
press the on/off button. When you press the on/off button again,
the Smartimer resumes the brushing cycle at the point where you
stopped.
The Smartimer automatically resets to the beginning of a -minute
cycle if:
you stop brushing for 30 seconds or longer;
you put the handle in the charger.
Quadpacer \ (specific models only)
The Quadpacer 30-second interval timer ensures that you brush
all sections of your mouth evenly and thoroughly. At 30, 60 and 90
seconds, you hear a short beep and notice a pause in brushing action.
These signals tell you to continue with the next section of your
mouth.
Battery charge indication (specific models only)
When the battery is running low, you hear 5 beeps after the -
minute brushing cycle and the charging light blinks rapidly.
When you hear the low charge indication, there are 3 or fewer 2-minute
brushings left.
,
,
,
,
-
-
,
,
1
2
4
3
1
2
4
3
EngliSh