Philips HF3480 - Manual (Page 12)

Tip: When you use the appliance for the first time, set the light intensity to
20. The moment you wake up, check which light intensity level the appliance
has reached by slightly moving the top dial up or down. When you do this, the
current alarm light intensity level appears on the display. Set the alarm light
intensity to this level for the next day.
1 Push the control lever down to the middle position to switch on
the alarm. (Fig. 9)
, The hour indication of the alarm time flashes (Fig. 10).
, To adjust the alarm time, follow steps 2 to 5 below. If the alarm
time is correct, just wait a few seconds.
2 Move the middle dial up or down to select the hour.
Note: You can only do this when the hour indication flashes. If this is not the
case, push the control lever up and down again to enter the alarm time
function.
Note: You can also use the middle dial to select the alarm time function and
set the alarm time (see section ‘Middle dial’ in this chapter).
3 Press the middle dial gently and release it to confirm.
, The minute indication of the alarm time starts to flash (Fig. 11).
4 Move the middle dial up or down to select the minutes.
5 Press the middle dial gently and release it to confirm or wait for a
few seconds.
, The appliance leaves the menu and the display shows the clock
time.
The alarm time is now set.
switching off the alarm
To switch off the alarm, push up the control lever to the top position.
Note: The lamp stays on. Press the top dial gently and release it to switch off
the lamp.
Note: The alarm (sound and/or light) automatically switches off after 90
minutes.
EnglisH 12