Philips SE6580 - Manual (Page 16)

14 Getting started
5 Getting started
Be sure to charge the handset for at least
24 hours before using it for the first time.
5.1 Connect the charger
1 Place the charger near a power
outlet.
2 Connect the power cable to the
connector on the charger.
3 Connect the other end of the
power cable to the power outlet.
Power is applied when the power
adaptor is plugged into the charger and
connected to the power outlet. The only
way to power down the charger is to
unplug the power adaptor from the
power outlet. Therefore, ensure that the
power outlet is easily accessible.
The power adaptor must be connected
correctly, as incorrect connection could
damage the unit.
5.2 Install the batteries
Always use the AAA rechargeable
batteries supplied with your handset. If
alkaline batteries are used instead of
rechargeable batteries, “Warning Batt”
will show on the display and the battery
icon will blink quickly.
1 Slide out the battery cover.
2 Place the batteries in the correct
polarity as indicated and replace the
cover.
5.3 Charge the batteries
The handset must be charged for at least
24 hours before using it for the first time.
When the battery level becomes low, the
low battery sensor warns you by blinking
the battery icon. If this occurs during a
conversation, an alert tone sounds to
Warning
Warning
Warning
01GB04C02.fm Page 14 Thursday, November 20, 2008 1:50 PM