Pentax R-315(N) - Manual (Page 63)

61
8 INITIAL SETTING
8-10 Initial Setting 5
1. Selection of Transfer rate (baud rate) : [BAUD UNIT]
Select a baud rate of 1200, 2400, 4800, or 9600.
2. Selection of Data bits : [DATA LENGTH]
Select a data length of 8 bits or 7 bits.
3. Selection of Parity : [PARITY BITS]
Select no (NIL) parity bit, even parity, or odd parity.
4. Selection of Stop bit : [STOP BITS]
Select the number of stop bits to be used: 1 or 2.
5. Selection of Control signal : [SIGNAL CONTROL]
Select whether the control signal is effective or not.
6. Selection of XON/XOFF : [XON/XOFF]
Select whether to enable or disable XON/XOFF.
7. Selection of Through command : [THROUGH
COMMAND]
Select whether to disable data output without receiving
any data request command or enable the “a” to “f”
command data output.
1. 1200
2. 2400
3. 4800
4. 9600
1. 8
2. 7
1. NIL
2. EVEN
3. ODD
1. 1
2. 2
1. ON
2. OFF
1. ON
2. OFF
1. NIL
2. a
3. b
4. c
5. d
6. e
7. f
PENTAX R-300 (p53-64) 10/30/02 11:13 AM Page 61