Messages 100, Under, Standing auto ta and eq error messages on – Pioneer AV Receiver/DVD Payer with 6.5 inch Wide Display AVH-P5700DVD User Manual
Page 100: Error messages, Understanding auto ta and eq error messages, Additionalinformation

Error messages
When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error
message.
Message
Cause
Action (See)
ERROR-02
Dirty disc
Clean disc.
Scratched disc
Replace disc.
ERROR-05
Electrical or mechanical
Press RESET.
DIFFERENT REGION DISC (RE-
GION ERR)
The disc does not have the same re-
gion number as this unit
Replace the DVD video with one bearing the
correct region number.
NON PLAYABLE DISC (NON-
PLAY)
This type of disc cannot be played
by this unit
Replace the disc with one this unit can play.
The disc is loaded upside down
Check that the disc is loaded correctly.
THERMAL PROTECTION IN
MOTION (TEMP)
The temperature of this unit is out-
side the normal operating range
Wait until the units temperature returns to
within normal operating limits.
PROTECT
All the files on the inserted disc are
secured by digital rights manage-
ment (DRM)
Replace disc.
TRK SKIPPED
The inserted disc contains WMA
files that are protected by digital
rights management (DRM)
Replace disc.
Understanding auto TA and EQ error messages
When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.
Message
Cause
Action
Error check MIC
Microphone is not connected.
Plug the supplied microphone securely into
the jack.
Error check front SP, Error
check FL SP, Error check FR SP,
Error check center SP, Error
check RL SP, Error check RR SP,
Error check subwoofer
The microphone cannot pick up the
measuring tone of a speaker.
! Confirm that the speakers are connected
correctly.
! Correct the input level setting of the power
amp connected to the speakers.
! Set the microphone correctly.
Error check noise
The surrounding noise level is too
high.
! Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.
! Set the microphone correctly.
AdditionalInformation
En
100
Appendix