beautypg.com

Multipoint calls – Polycom VSX7000E User Manual

Page 7

background image

6

MULTIPOINT CALLS

1.

Point to Point calls are when only two sites are connected. Multipoint calls are

when several sites are connected in a call. The VSX7000e can connect up to four

sites, your site and three others.

2.

To add second site to a call, press the green Call/Hang Up button. Highlight Add

Call, and either manually type in the IP address or choose the address from the

Directory.

3.

When in a multipoint call, there are four different viewing modes for the remote

site, automatic, discussion, presentation, and full screen.

4.

To change the multi-point mode, select System (lower left corner on the Place a

Call screen), select Admin Settings, select Monitors, select Multipoint Setup, the

scroll to the desired Multipoint mode and select it by pressing Enter.

5.

Automatic is the default mode and switches between discussion and presentation

modes automatically based on the interaction between the sites.

6.

Discussion mode will show all sites involved in a call in a split screen, which all

sites can see. (This will be shown on the back monitor.)

7.

Presentation mode shows the teacher full screen on the far site’s screen. The

teacher will see the far site on the back monitor. (This is usually the

recommended setting for teaching.)

8.

Full screen mode is voice activated and will show whichever site is speaking full

screen.

9.

A multipoint call can be ended by hanging up all calls at the same time or

individually.