Setting radio channels – Polycom XS-3900 User Manual
Page 8
Configuration Guide
8
PN: 1725-36061-001_C.doc
Setting Radio Channels
With the SpectraLink Wireless Telephones operating in 802.11b mode,
at least one of the Wireless LAN Array’s Integrated Access Points
(IAPs) must be set to the 2.4 GHz band. Any of the Array’s four abg
radios may be used, and up to three may be used simultaneously.
However, the radios must be set to the non-overlapping channels 1, 6,
and 11. This may be done using the following CLI commands:
Xirrus_WLAN_Array# configure
Xirrus_WLAN_Array(config)# interface iap
Xirrus_WLAN_Array(config-iap)# abg1 channel 11
Xirrus_WLAN_Array(config-iap)# abg3 channel 1
Xirrus_WLAN_Array(config-iap)# abg4 channel 6