Philips WP3820 - Manual (Page 9)

The granular activated carbon removes the unpleasant chlorine smell
and taste from your tap water.
The LCD display on the water purifier shows the current remaining
filter capacity. A remaining filter capacity of 0 tells you that you
have to replace the filter. Philips’ unique cartridge replacement
indicator also helps you to determine when to replace the filter.
The high-speed initial flow rate of 2 litres per minute gives you plenty
of clean water instantly.
The water selection lever offers you a choice of three water flow
types: unfiltered spray, unfiltered stream or filtered spray.
The nine tap-mounting adapters supplied with the water purifier
allow easy installation on almost any type of tap.
The bayonet-type mount ensures quick, easy and secure filter
cartridge replacement.
Preparing for use
inserting the battery
Before you insert the battery, make sure your hands and the water
purifier are dry.
Keep away from the kitchen sink to prevent the battery from falling
down the drain.
Insert the battery before you install the water purifier on the tap.
1 Use a coin to turn the battery compartment cover on the back of
the water purifier in the ‘OPEN’ direction. Remove the battery
compartment cover (Fig. 2).
Place the battery (included) in the cover, with the + pole facing the
battery compartment cover (Fig. 3).
Place the battery compartment cover back onto the water purifier
in such a way that the ‘%’ mark on the cover is aligned with the ‘I’
mark on the water purifier. (Fig. 4)
Use a coin to turn the battery cover in the ‘CLOSE’ direction until
the ‘I’ mark on the cover is aligned with the ‘I’ mark on the water
purifier (Fig. 5).
-
-
-
-
-
-
-
-
-
English