Peavey CS 800H - Manual (Page 55)

55
B Bii--A Am mp p O Op pe erra attiio on n
(sub woofer & mid/high enclosure)
1. Set A AM MP P M MO OD DE E switch to S ST TE ER RE EO O.
2. Set the A channel A AM MP P FFU UN NC CT TIIO ON N switch to LLO OW W P PA AS SS S.
3. Turn on the A channel LLO OW W C CU UT T S SW WT TIIC CH H .
4. Set channel A LLO OW W C CU UT T frequency adjustment knob to match the low frequency cut-off or the -3 dB down point
of the sub woofer. (If you don’t know this specification‚ set it for 40 Hz.)
5. Set the channel A C CR RO OS SS SO OV VE ER R frequency adjustment knob to the desired crossover frequency (usually
100–150 Hz).
6. Set the channel B A AM MP P FFU UN NC CT TIIO ON N switch to FULL RANGE.
7. Plug a short shielded cable into the Channel A LLo ow w P Pa assss output .
8. Connect the other end of the same cable to the channel B input .
9. Connect the Mono program signal to the channel A input .
10. Connect the sub woofer(s) (in parallel) to the channel A output .
11. Connect the mid/high enclosure(s) (in parallel) to the channel B output .
1
9
2
4
5
6
7
8
9
10
11
3
5 3 4 7 1 8 6
10 11
2