Philips AZ 1018 - Manual (Page 6)

CD Player
Display indication
– Cd
OPEN : CD door open
– d1SC: when reading CD contents
– In stop mode: total track number and
total playback time
– During CD playback: elapsed
playback time of current track and
current track number
– Pause: elapsed playback time freezes
and flashes
– SHUFFLE / REPEAT modes: when the
respective mode is activated
– PROGRAM : when CD programme active;
Prog also appears briefly when you
store a track
– no SEL: programme activated but no
tracks selected
– FULL: programme memory full
–
no Prog: programme cancelled
– Cd Err, no d1SC or nF d1SC:
error in CD operation /no disc/ or a
CD-R(W) is blank or the disc is not
finalized (see Troubleshooting)
Playing a CD
This CD-player can play all kinds of Audio
Discs such as CD-Recordables and CD-
Rewritables. Do not try to play a CD-ROM,
CDi,VCD, DVD or computer CD.
1 Adjust the POWER slider to CD.
➜ Display: shows Cd briefly.
2 To open the CD door, lift the CD door at
the edge marked LIFT TO OPEN.
3 Insert a CD or CD-R(W) with the printed
side facing up and press the CD door gently
close.
4 Press PLAY•PAUSE 2; on the set to
start playback.
5 To pause playback press PLAY•PAUSE
2;.To resume, press PLAY•PAUSE 2;
again.
➜ The elapsed playback time freezes and
flashes.
6 To stop CD playback, press STOP 9.
7 To switch off the set, adjust the POWER
slider to TAPE/ OFF position and check
the cassette keys are released.
Note: CD play will also stop when:
– you open the CD compartment;
– you select RADIO or TAPE sound
source;
– the CD has reached to the end.
CD-Player
9
English
TAP OFF MWFM CD
PLAY
STO P • O PEN
PAU SE
SEAR CH
RECO RD
POWE R
VOLUME
CD MODE
PROGRAM
PRES ET
SEA RCH
PLAY- PAUSE
STOP
FM•M W
AZ1018 CD RADIO C ASSETT E REC ORDE R
N EP O O T T F I L
BATT LOW
XP AZ 1018/00-1 13-12-2000 11:55 Pagina 9