beautypg.com

Troubleshooting – Philips AZ 1018 User Manual

Page 12

background image

15

English

If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or
service centre.

WARNING: Under no circumstances should you try to repair the set yourself, as this
will invalidate the guarantee.

Troubleshooting

Problem

Solution

No sound

– Adjust the VOLUME

No power

– Mains lead not securely connected.
Connect AC mains lead properly
– Batteries exhausted /incorrectly inserted.

Insert (fresh) batteries correctly

Display does not function

– Electrostatic discharge

properly/ No reaction to

Switch off and unplug the set.

operation of any of the

Reconnect after a few seconds.

controls

no d1SC, Cd Err or

– No CD inserted, insert a CD

nF d1SC indication

– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)
– CD-R(W) is blank or the disc is not finalized.
Use a finalized CD-R(W)
– Laser lens steamed up. Wait until lens has acclimatized

Laser lens steamed up

– Wait until lens has cleared
– Wait until lens has acclimatized

CD playback does not work

– CD badly scratched/ dirty.
Replace/ clean CD (see maintenance)

The CD skips tracks

– CD damaged or dirty. Replace or clean CD.
– Programme is active. Quit programme mode

Poor cassette sound quality

– Dust and dirt on the heads, etc.
Clean deck parts, see maintenance.
– Use of incompatible cassette types (METAL or
CHROME). Only use NORMAL (IEC I) for recording

Recording does not work

– Cassette tab(s) may be broken.
Apply a piece of adhesive tape over the missing tab space.

XP AZ 1018/00-1 13-12-2000 11:55 Pagina 15