Philips LTC 2600 - Manual (Page 36)

36
LTC 2600 Series Appendix C: Factory Default Settings
ITEM DEFAULT OPTIONS
CAMERA TITLE:
Camera Title
CAMERA 1
SEQUENCES:
Seq dwell full A
5 sec 1 - 60 sec.
Seq dwell quad A 5 sec 1 - 60 sec.
Seq dwell full B 5 sec 1 - 60 sec.
Seq dwell quad B 5 sec 1 - 60 sec.
Mon A full 1-16, 1-16 Any camera in a 32 camera sequence. i.e. 1,5,8,4,2,3,4
Mon A quad 1,2,3,4 Any camera to cameo assignment is allowed.
5,6,7,8 Note: 9 channel product has only 3 quads instead of 8.
9,10,11,12
13,14,15,16
1,2,3,4
5,6,7,8
9,10,11,12
13,14,15,16
Mon B full 1-16, 1-16 Any camera in a 32 camera sequence. i.e. 1,5,8,4,2,3,4
Mon B quad 5,6,7,8 Any camera to cameo assignment is allowed.
9,10,11,12 Note: 9 channel product has only 3 quads instead of 8.
13,14,15,16
1,2,3,4
5,6,7,8
9,10,11,12
13,14,15,16
CONFIGURE SETUPS:
Setup title
SETUP 1 Any 12 character title
System4 models ONLY:
PC/PRINTER/VCR:
Connect to
VCR RS232 printer; GUI, CCL,VCR, Camera ID.
Serial port 96,n,8,1 baud: 6,12,24,48,96,192.
parity: o(odd), e(even), n(none).
data bits: 7,8.
stop bit 1
Autoprint DISABLE ENABLE,DISABLE
LOG:
Log setup
all off. act, alm, evt, vl,err - all can be either selected or not selected.
PASSWORD:
Password
1111 1111 - 9999 where 1111 = no password
EXPAND SYSTEM:
Number mux
01 01 to 30
TIME EVENTS:
Setup on/off
OFF ON, OFF
Start time 00:00
Days SMTWTFS SMTWTFS ..any day or days of the week.
Run once only OFF ON, OFF
Record OFF ON,OFF