PYLE Audio PLCDCS300 - Manual (Page 6)

6
GENERAL OPERATION
Note: In this product design, there has
different sound accompanying with every
button pressed and the sound is
designed differently according to the
customers.
• ON/OFF
Switch on the unit by pressing POWER
button (9). When system is on, press
POWER button (9) again to turn off the
unit.
• SOUND ADJUSTMENT
Press PUSH SELECT button (10) to
select audio mode shown in the below
sequence.
By rotating the knob (10) clockwise or
counter-clockwise, it is possible to
adjust the desired sound quality.
If adjustment has not been done in
BAS/TRE/BAL/FAD mode, it is
returned to the volume select mode
(initial) 5 seconds later.
Note: Only in fader version, fader is
effective.
• LOUDNESS
Press the LOU button (3) to loudness
function and display will show
“LOUD”.
Press it again to release this function.
• DISPLAY
Press the DSP button (15) can switch
between frequency or play time display
and clock display. To set clock, hold
down DSP button (15) until the clock
is shown on display then press
TUNE/TRACK/SKIP button (17) to
change hours or TUNE/TRACK/SKIP
button (16) to change minutes.
• SELECT MODE
Press the MODE button (6) to choose
desired listening mode. (e.g. radio,
CDP, CDC, tape, TV or AUX mode)
• MUTE
Press the MUTE button (2) to silence
the receiver. Press it again to release
the mode.
• LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated
functions on the display (7).
• EQUALIZATION
Press EQUALIZER button (12) to
select SOUND EFFECT as shown in
below sequence:
Press EQUALIZER button (12) over 1
second, graphic display type will
display on the LCD and then press
TUNE/TRACK/SKIP button (16) or
TUNE/TRACK/SKIP button (17) to
select graphic display type as follows:
• REMOTE SENSOR (OPTIONAL)
Point the remote control handset to
the remote sensor IR (25).
Press the function keys on the handset
to control the system.
• AUXILIARY INPUT
The unit can be connected to a
portable audio player through the AUX
IN jack (11).
• RESET
RESET button (30) must be activated
with either a ball point pen or thin metal
object. The RESET button (30) is to
be activated for the following reasons:
- Initial installation of the unit when all
wiring is completed.
- All the function buttons do not
operate.
- Error symbol on the display.
OPERATION
VOLUME BASS TREBLE BALANCE FADER
(For Fader Version Only)
DNCO1 DNCO2 DNCO3 DNCO4 DNCO5
NORMAL CLAS POP JAZZ