Philips VOIP 080 - Manual (Page 10)

USING YOUR TELEPHONE
TO SCREEN CALLS
Call screening allows you to listen to messages being left on you answering machine.
You may then choose to intercept the call or not by pressing
.
To start call screening, press .
You can hear the caller through the earpiece of your handset.
To stop call screening, press
.
For permanent adjustment, refer to the call screening section in the chapter concerning
programming the answering machine on page 11.
TO SWITCH ON/OFF THE ANSWERING MACHINE BY REMOTE CONTROL
Before using the remote access code to check calls on your answering machine, you must first
record a personal remote access code. The code is made up of 4 digits of your choice (see
programming the answering machine on page 11).
After you have recorded your remote access code.
TO PLAYBACK MESSAGES BY REMOTE CONTROL
* If the access code is correct, the messages are read automatically.
TO MANIPULATE THE MESSAGES BY REMOTE CONTROL
To delete the current message
ð
press the key on your telephone.
To listen to the previous message
ð
press the key twice on your telephone.
To listen to the next message
ð
press the key on your telephone.
9
Dial your
telephone
number
р р +
р
Your answering
machine has been
switched on
Enter your
remote access
code
Wait for the
9th ring
+
Press
Dial your
telephone
number
р р +
р
Your answering
machine has been
switched off
Enter your
remote access
code
During the
outgoing
message
+
Press
Dial your
telephone
number
ð The answering
machine answers
ð
Enter your
remote access
code *
ð Hang up at the
end of the call
+
ang6523.qxd 31/05/99 15:20 Page 9