Voice – Phonetics Sensaphone ISACC 5000 User Manual
Page 68
68
Sensaphone
®
ISACC Instruction Manual
VOICE
This keyword command allows you to select the input and output status information to be
recited when you call into the unit for a status report using a standard telephone.
To display the information to be recited during a voice status report, type show voice after an
ISACC prompt:
ISACC>show voice
VOICE STATUS SELECTION
IN01 = "LOW WELL FLOAT "
= Yes
IN02 = "HI SUMP FLOAT "
= Yes
IN03 = "Input #3 "
= Yes
IN04 = "FLOW RATE (GPM) "
= Yes
IN05 = "WELL LEVEL (FT) "
= Yes
IN06 = "RESET "
= Yes
IN07 = "Input #7 "
= Yes
IN08 = "VOLTAGE "
= Yes
IN09 = "Input #9 "
= Yes
IN10 = "Input #10 "
= Yes
IN11 = "Input #11 "
= Yes
IN12 = "Input #12 "
= Yes
IN13 = "Input #13 "
= Yes
IN14 = "Input #14 "
= Yes
IN15 = "Input #15 "
= Yes
IN16 = "Input #16 "
= Yes
OUT01 = "WATER PUMP RELAY"
= Yes
OUT02 = "LOW WELL LIGHT "
= Yes
OUT03 = "HI SUMP LIGHT "
= Yes
OUT04 = "Output #4 "
= Yes
OUT05 = "Output #5 "
= Yes
OUT06 = "Output #6 "
= Yes
OUT07 = "Output #7 "
= Yes
OUT08 = "Output #8 "
= Yes
OUT09 = "On board buzzer "
= Yes
OUT10 = "On board relay "
= Yes
OUT11 = "CONTROL VALVE "
= Yes
OUT12 = "Analog output #2"
= Yes
OUT13 = "Analog output #3"
= Yes
OUT14 = "Analog output #4"
= Yes
To program the information to be provided in the voice status report, type set voice after an
ISACC prompt. At the prompt, enter Y to include the information, or N to exclude. Press
ENTER to go to the next parameter:
ISACC>set voice
VOICE STATUS SELECTION
IN01 = "LOW WELL FLOAT " = Yes (Y or N) >
IN02 = "HI SUMP FLOAT " = Yes (Y or N) >
IN03 = "Input #3 " = Yes (Y or N) >
IN04 = "FLOW RATE (GPM) " = Yes (Y or N) >
IN05 = "WELL LEVEL (FT) " = Yes (Y or N) >
IN06 = "RESET " = Yes (Y or N) >
IN07 = "Input #7 " = Yes (Y or N) >N
IN08 = "VOLTAGE " = Yes (Y or N) >
IN09 = "Input #9 " = Yes (Y or N) >N
IN10 = "Input #10 "
= Yes (Y or N) >N
IN11 = "Input #11 "
= Yes (Y or N) >N