Phonetics Sensaphone ISACC 5000 User Manual
Page 66
66
Sensaphone
®
ISACC Instruction Manual
3 for Voice
4 for Beeper
5 for External Modem
PH01, Num =
>14078546142b123456789**I
Dialing mode = (Voice
) >4
Name = "Phone #1
" >Engineer Beeper
PH02, Num =
>16105551290
Dialing mode = (Voice
) >
Name = "Phone #2
" >DIF phone
PH03, Num =
>12035554044
Dialing mode = (Voice
) >
Name = "Phone #3
" >Office
PH04, Num =
>12155559854
Dialing mode = (Voice
) >1
Name = "Phone #4
" >Manager
PH05, Num =
>5554538
Dialing mode = (Voice
) >1
Name = "Phone #5
" >M. Weaver
PH06, Num = >5559605
Dialing mode = (Voice
) >1
Name = "Phone #6
" >J. Hogan
PH07, Num = >17175556886
Dialing mode = (Voice
) >1
Name = "Phone #7
" >A. Daniels
PH08, Num = >16035556453
Dialing mode = (Voice
) >0
Name = "Phone #8
" >M. Otto
DIALING CODES
: Sometimes ISACC may need special instructions when dialing out on
certain phone systems, long distance phone services, to access an outside phone line, or to
beepers. The dialout codes give ISACC instructions on how to set the phone digits when
dialing the phone number. Each code is counted as one digit toward the total of 32 digits.
The dialout codes are:
P = two second pause
W = wait for dial tone
B = wait for beeper tone
A = wait for phone to be answered
I = send alarm input digits
P = two second pause
: A two second pause can be placed anywhere within the phone
number by typing the letter P (upper or lower case). The pause takes up one digit and may be
used more than once.
W = wait for dial tone
: This code instructs ISACC to wait until a dial tone is detected on
the phone line before it continues dialing. This is needed when a second dial tone, such as for
an outside line, is present. ISACC automatically waits for the first dial tone. If the second dial
tone is not detected after 10 seconds, ISACC will dial automatically.
Example: 9 W 5555674
B = wait for beeper tone
: This code instructs ISACC to wait for a tone from the beeper
company before it sends the remaining digits.
Example: 16105552376 B 123456
A = wait for a phone to be answered
: This code instructs ISACC to wait for the phone
to stop ringing before it continues sending digits when dialing to a beeper. This allows you to
essentially force call progress in the middle of the phone dialing when the beeper service does
not produce a tone when ready.
Example: 16105554593 A 234567
I = send alarm input digits
: This code is used only when dialing to a beeper. After the call
is received by the beeper company, the code I instructs ISACC to send a two-digit number(s)
indicating which input(s) is in alarm.
Example: 16025553487 B 1235679 I