Phonetics Sensaphone ISACC 5000 - Manual (Page 62)

62
Sensaphone ® ISACC Instruction Manual
ALARMS
The keyword command SHOW ALARMS will display the present status of the inputs in
alarm, if any alarms exist. The prefix SET is not valid with this keyword.
To display the current input alarm status, type show alarms at an ISACC prompt:
ISACC>show alarms
DIALOUT ALARM STATUS
No alarms
DIALOUT
This command allows you to enable or disable an input’s ability to cause a dialout during an
alarm on that input. If the input is enabled, an alarm on that input will initiate a dialout. If
the input is disabled, ISACC will not dialout if an alarm occurs on that input.
To display the input dialout programming, type show dialout after an ISACC prompt. You
may also display the dialout programming for a specific input by typing show dialout followed
by the input number.
ISACC>show dialout
DIALOUT ENABLING
IN01 = "LOW WELL FLOAT " = Yes
IN02 = "HI SUMP FLOAT " = Yes
IN03 = "Input #3 " = Yes
IN04 = "FLOW RATE (GPM) " = Yes
IN05 = "WELL LEVEL (FT) " = Yes
IN06 = "RESET " = Yes
IN07 = "Input #7 " = Yes
IN08 = "VOLTAGE " = Yes
IN09 = "Input #9 " = Yes
IN10 = "Input #10 " = Yes
IN11 = "Input #11 " = Yes
IN12 = "Input #12 " = Yes
IN13 = "Input #13 " = Yes
IN14 = "Input #14 " = Yes
IN15 = "Input #15 " = Yes
IN16 = "Input #16 " = Yes
To program the dialout for an input, type set dialout after ISACC prompt. To enable the
input for dialout, type Y after prompt. To disable the input for dialout, type N at the prompt.
You may also program the dialout for a specific input by typing set dialout followed by the
input number.
ISACC>set dialout
DIALOUT ENABLING
IN01 = "LOW WELL FLOAT " = Yes (Y or N) >
IN02 = "HI SUMP FLOAT " = Yes (Y or N) >
IN03 = "Input #3 " = Yes (Y or N) >N
IN04 = "FLOW RATE (GPM) " = Yes (Y or N) >
IN05 = "WELL LEVEL (FT) " = Yes (Y or N) >
IN06 = "RESET " = Yes (Y or N) >
IN07 = "Input #7 " = Yes (Y or N) >N
IN08 = "VOLTAGE " = Yes (Y or N) >
IN09 = "Input #9 " = Yes (Y or N) >N