Phase Technology SPF-15 User Manual
Page 2
8650 College Boulevard / Overland Park, KS 66215 / (888)PHASE TK / www.phasetech.com / www.mseaudio.com
1. Unpack speaker.
5. Attach speaker to surface
using installer-supplied
fasteners.
6. Aim speaker by pointing
it up or down and/or
rotating it.
3b. If mounting speaker
offset from wiring point, run
wire out hole in wall and
behind base plate through 2
mm standoff gap between
base plate and wall. The
standoff gap accepts up to
18 gauge flat signal wire.
4. Choose a secure
mounting surface with
sufficient strength to reliably
hold the speaker.
3a. If mounting the speaker
directly over the wire,
ensure the base plate
covers the hole in wall.
7. Done!
2. Connect speaker wire
leads to the terminal screws
on the back of the base
plate. Polarity is indicated.
Install instructions for SPF-15, Page 2