Panasonic EY7440-U1 - Manual (Page 8)

Ref. No. 2G Procedure 2A → → → → 2B → → → → 2C→ → → → 2D→ → → → 2E→ → → → 2F→ → → →
2G
Attachment of the Housing.
1. Place the driving block onto the housing A and place the spring
for release lever and the hook release lever.
2. Place the switch assembly, operation panel, click spring and F/R
selector handle onto the housing A.
NOTE :
Make sure that the lead wires are pressed fit firmly.
3. Close the housing A and B with pushing the radiating plate on the
direction of the arrow and tighten 8 housing screws.
NOTE :
Confirm to set the radiating plate properly. If the radiating plate
lean toward the motor brush side, the housing B can not be
closed.
4. Place the H/L change handle into the rail properly.
5. Insert the belt hook into the housing and tighten with hook bolt.
8
EY7440-U1 /