PYLE Audio PWLB006 - Manual (Page 2)

A B D C E I G H
Fig 1
Step 1
Important
Determine the desired location
for the monitor.
Make sure there is
adequate mounting space
available for the monitor,
considering the monitor dimensions.
This mount is supplied with the
necessary hardware for either
Wooden Stud Mounting or
Masonry Mounting. Determine
your mounting type and proceed accordingly.
:
Step 1
Important
Step 2
Wooden Stud Mounting:
Using an electronic stud finder, locate the center of the wooden stud.
Position the Wall Plate (2) in desired mounting location over stud.
Level the Wall Plate with a bubble level, and then using the wall plate
as a template, mark mounting hole locations over the center of the stud.
Drill 2 mounting holes 50mm deep, into the stud using a 3mm drill bit.
Step 2
Wooden Stud Mounting:
Position the Wall Plate (2) in desired mounting location on wall.
Level the Wall Plate with a bubble level, and then using the wall plate
as a template, mark mounting hole locations on wall.
Drill 2 mounting holes 50mm deep, using a 8mm masonry bit. Insert
Wall Anchors (I) into the mounting holes, and lightly tap them flush to
the wall with a hammer.
Wall Anchors should only be used for masonry mounting.
use wall anchors to mount the mount to drywall.
Securely mount Wall Plate with supplied Long Blot (H) and washer(F).
Masonry Mounting:
Caution:
NEVER
Masonry Mounting:
Caution:
NEVER
Step 3
Caution:
Attach Monitor Plate to back of the monitor with 4mm , 5mm or 1 4”-20x5 8”
supplied hardware. (A-E) (Fig. 2) Check the monitor’s owners manual
for correct length screw to use.
Never force screws into the monitor, as damage may occur.
/ /
Step 3
Caution:
Description
A
3
B
D
C
E
F
G
1
1
4
4
2
4
4
4
H
I
6
4
2
Letter
Monitor Plate
Wall Plate
M4x12 bolt
M4x8 bolt
M5x10 Safety bolt
Long bolt
Wall anchor
Qty
M5x12 bolt
1 4 -20x5 8 bolt
/ / ” ”
M5x8 bolt
M5 washer
M6 washer
2
1
2
Parts:
1 2
F
3
Fig 2
A,B,C,D,
E
F
G
-3- -2-