PYLE Audio PSW112 - Manual

Warning: Some TV require two people to lift, as we are not responsible for any
personal injur y or product damage due to mishandling. Warning:
Fig 3a Fig 3b
Item No.:PSW112 Item No.:PSW112
Step 3: Hanging display
Firstly lift the bracket mounted display over the wall mount. And then hook the
brackets over the top of the wall mount. Rotate the display let the bottom of the
brackets hook over the bottom of wall mount, as shown in Fig.3a. Then put safe
bolts into the bottom of the brackets and lock it, as shown in Fig.3b.
Step 3: Hanging display
Fig 2b Fig 2c
-8-
Multifunctional double deck wall mount
Fixed Flat Panel TV Bracket
INSTALLATION GUIDE
IMPORTANT: If don’t understand about right install ways, please
consult to normal installing specialist .
IMPORTANT:
Easy installing: Just hang up the display
Safety: locking by spining bolt on the bottom
Max load capacity:75kg(165lbs
TV size range: 36 ~55
,
）
" "
Brick, Concrete and Stone wall(Fig 2c):
Using the wall mount as template to mark 6 holes location on the wall. There holes are
located at the top row of the slots and three more are located at the bottom row. The
outer holes must be fall to the left and right of the two holes in the middle of the
mount. Please make sure these holes are level and at least 6” between any two lines.
Pre-drill these holes with a 10mm drill bit to at least 80mm deep hole. Insert Wall
anchors(P) into each of these holes. Attach the wall mount to the wall using 6 Long
bolts(O) and washers(Q). Brick, Concrete and Stone wall(Fig 2c):
2,3
4 1
O
1
Q