Philips CDR-775 - Manual (Page 21)

Autostart recording
This feature enables you to make fast and easy recordings
of an external source.The recorder will detect the start of
the source and track increments are automatically detected
from digital source material.Track increments can be added
manually.
Preparing
1
Place an unfinalized CDR(W), absolutely free of scratches
and dust particles in the left CDR tray.
2
Press SOURCE repeatedly to select the type of connection
to your source of recording:
➜
DIGITAL I , OPTICAL I or ANALOG lights up and
DIGITAL 1, OPTICAL or ANALOG appears on the
display.
Examples:
- CD-player is connected with its digital out connector
directly to the digital in connector of your CD-recorder:
connection is DIGITAL I.
- CD-player is connected with its analog out connectors
directly to analog in connectors of your CD-recorder:
connection is ANALOG.
- Turntable is connected with its analog out connectors to
amplifier/receiver which is connected to the analog in
connectors of your CD-recorder: connection is
ANALOG.
3
With the CD recorder stopped press REC TYPE four times
to select
REC EXT DISC.
➜
SYNC starts to flash and the display shows REC EXT
DISC followed by WAIT. After a few seconds PRESS
RECORD followed by the remaining time and track
number appear on the display.
0 If CHECK INPUT message and the input label
DIGITAL I or
OPTICAL I also flashes, switch on the external source, check
the digital connection or select the right input with the
SOURCE key.
0 You can record a 3-second silence at the start of a track by
pressing PLAY/PAUSE 2; on the CD recorder before
starting the recording.
Recording
4
To start recording, press PLAY on the external CD player.
➜ d lights continuously.The track number and recording
time left appear on the display.
Note: In case the recording does not start use the Manual
recording mode. See previous paragraph: ‘Recording from LP’s or
cassettes’.
0 To interrupt recording, press PLAY/PAUSE 2; on the
CD recorder.
➜ d starts to flash. Resume at step
1 .
0 If, however, you start the source during a track, recording
will start at the beginning of the next track or after
2.7 seconds of silence in analog recordings.
0 Track numbers are automatically incremented. During an
analog recording you can insert additional track numbers
during recording by simply pressing TRACK INCR. on the
remote control.
0 The EASY JOG/ENTER key can be used to adjust the
recording level.The setting of the recording level is stored
in the recorder’s memory.
0 The recorder stops automatically in case of digital recording
from a CD. With AUTO TRACK ON, the recorder pauses
and waits for a new track for 1 minute before going to
stop. Recordings from DAT, DCC or analog sources will
only stop after 20 seconds of silence.
5
To stop recording, press STOP 9 on the CD recorder.
➜
UPDATE lights up and d goes out.
After recording the display will show UPDATE for several
seconds.
Finalizing
If you want to play the recorded CD(RW) on a normal
CD player, you must first finalize the disc. Please note that
you cannot add anymore tracks on a finalized CDR.
See Finalizing CDR and CDRW discs.
OPEN / CLOSE PLAY / PAUSE STOP REC TYPE OPEN / CLOSE PLAY / PAUSE STOP EXT SOURCE ERASE FINALIZE
CDR
RECORD
AUDIO CD PLAYBACK
PHONES
AUDIO CD PLAYBACK
DISPLAY SCROLL DJ MODE REPEAT SHUFFLE PROG
CDR 77X AUDIO CD RECORDER
ANALOG RW
How to record from an external source
21
English
xp CDR 775/00.1 english 10-07-2001 13:19 Pagina 21