Proxima ASA 7911 - Manual (Page 65)

59
If you have written, or plan to write, a custom application to
allow communication between the RangeLAN2 Serial Adapter
and an Ethernet device, set the TCP Close Connection Signal
parameter to “Yes.” When this parameter is enabled, the Serial
Adapter will close an existing TCP connection upon receipt of
the “$QUIT” command from a remote workstation.
For more information on the “$QUIT” command and for a
discussion of how to establish communication between a Serial
Adapter and an Ethernet device, see Chapter 3 and Appendix B,
the Serial Adapter TCP/IP Specification.
By default, the TCP Close Connection Signal is disabled and set
to “No.”
The Serial Adapter configuration menu contains several param-
eters that are not needed for normal operation. A password is
required to enable Technical Support Access to view these
additional parameters.
If you call Proxim Technical Support, they may ask you to
enable the Support parameters, but, in general, you will not need
to view or change these parameters during normal operation.