Philips SCD600 - Manual (Page 8)

- ThE SYMBol ShoWn in FigUrE 2 inDiCaTES, For ThE SaFETY oF
EVErYonE in YoUr hoUSEholD, ThaT UninSUlaTED MaTErial
WiThin YoUr proDUCT MaY CaUSE an ElECTriCal ShoCK. EXCEpT
For ThE BaTTErY CoMparTMEnT, plEaSE Do noT opEn ThE
hoUSing oF ThE BaBY UniT anD parEnT UniT in orDEr To prEVEnT
ElECTriC ShoCK (Fig. 2).
Adapter for baby unit:
- Input: 100-240 VAC 50/60Hz
- Output: 6.0 VDC 0.8A
- Adapter no. OH-1048A0600800U1
Adapter for parent unit:
- Input: 100-240 VAC 50/60Hz
- Output: 6.0 VDC 0.8A
- Adapter no. OH-1048A0600800U1
The electrical outlet shall be installed near the equipment and shall be easily accessible.
For the baby unit, only use 1.5V AAA alkaline batteries (batteries not supplied).
For the parent unit, only use the SCD600 Li-Ion rechargeable battery as supplied with the appliance.
Dispose of used batteries according to the instructions.
Compliance information
The FCC ID number is located on the casing bottom of the parent unit and in the battery
compartment of the baby unit.
The term ‘IC’ before the certification number signifies that Industry Canada technical specifications
were met.This certification means that the equipment meets certain radio communications and
operational requirements. This device complies with Part 15 of the FCC Rules and RSS-210 of
Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
radio interference
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules and ICES-003 of Industry Canada. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
rF radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 7 3/4
inches / 20 centimeters between the radiator and your body. For handheld operation, this
equipment has been tested and meets the FCC RF exposure guidelines. For body-worn operation,
this product has been tested and meets the FCC RF exposure guideline when used with the belt
clip supplied with this product. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter. Use of other accessories may not ensure compliance with
FCC RF exposure guidelines. This equipment also complies with Industry Canada RSS-102 with
respect to Canada’s Health Code 6 for Exposure of Humans to RF Fields.
EngliSh 8