Power supply, Using ac mains, Switching power on/off: save energy – Philips AZ1080 User Manual
Page 8: General operation, And check if the cassette keys are released, Position and check the cassette keys are released, Play stop • ope n paus e sear ch sear ch
7
English
Incorrect use of batteries can cause
electrolyte leakage and will corrode the
compartment or cause the batteries to
burst.Therefore:
• Do not mix battery types: e.g. alkaline with
carbon zinc. Only use batteries of the same
type for the set.
• When inserting new batteries, do not try to
mix old batteries with the new ones.
• Remove the batteries if the set is not to be
used for a long time.
Using AC Mains
1 Check if the mains voltage, as shown on
the type plate located on the bottom
of the set, corresponds to your local
mains supply. If it does not, consult your
dealer or service centre.
2 Connect the mains lead to the AC MAINS
inlet and the wall socket.The mains supply is
now connected and ready for use.
3 To switch off completely, unplug the mains
lead from the wall socket.
• Unplug the mains lead from the wall socket
to protect your set during heavy
thunderstorms.
The type plate is located on the
bottom of the set.
Switching power on/off:
Save energy
Whether you are using mains or battery
supply, to avoid unnecessary energy
consumption always adjust the source
selector to TAPE/
OFF
and check if the
cassette keys are released.
General operation
1 To select your sound source adjust the
source selector to CD, MW, FM or
TAPE/
OFF
.
2 Adjust the sound with the VOLUME and
DBB (Dynamic Bass Boost) controls.
3 To switch off the set, adjust the source
selector to TAPE/
OFF
position and check
the cassette keys are released.
Power Supply
A
~
REPEAT
TAP
OFF
MW
FM
CD
LIFT
T O O PE N
AZ108
0
CD SO
UNDMA
CHINE
CD R
EWR
ITABLE
COMPATIBLE
PLAY
STOP
• OPE
N
PAUS
E
SEAR
CH
SEAR
CH
SE
ARCH
ST
O
P
D
Y
N
AM
IC BASS
BOOS
T
P
L
A
Y
/
P
A
U
S
E
DBB
SHUFFLE
RE
PE
AT
VOLU
M
E
N
EP
O
O
T
T
F
I
L
TUNING
CD TRA
CK
AZ1080/00A 03/13/02 10:06 Page 7