beautypg.com

Configuring the a 21 for bridged mono operation – Parasound A 21 User Manual

Page 9

background image

CONFIGURING THE A 21 FOR BRIDGED MONO OPERATION

6

YOU SHOULD KNOW

IMPORTANT! - Before Trying Bridged Mono

You should not connect a speaker with an impedance of less than 8

to the A 21 when it is

configured for bridged mono operation. Refer to Bridged Mono Operation in the Technically

Speaking section for additional information about. Use the right channel Gain control to

adjust level in the bridged mode.

1

2

3

6

4

5

7

8

Speaker

7

6

4

5

8

8

2

3

8

1

Right

Left

Components

Surround

Sound

Controller

Preamp

OUTPUTS

In certain applications, you may require your A 21 to power a single 8 Ω speaker by

using its bridged mono feature. In most instances, you won’t use the A 21 this way and

you can skip this section.

What You’ll Need:

• One length of speaker wire with banana plugs, spade lugs, or bare wires

• One shielded balanced or unbalanced interconnect cable for each A 21 used

in bridged mono

• One loudspeaker with an impedance of 8

or higher

Before Connecting

Remove power to all the components in your audio system.

Set the A 21 Stereo - Mono Bridge Switch to its Mono (up) position.

To Connect: From the Source

Plug one end of the interconnect cable into the Balanced or Unbalanced Right

Channel & Mono Input jack on the A 21

Plug the other end of this cable into the desired output channel on the preamplifier

or surround controller.

Do not make any connection to either Left Channel Input jack on the A 21.

To Connect: To the Speaker

Insert the wire with the ridge or other marking into the red Right

+

(positive) speaker

terminal on the A 21. (This is the positive speaker terminal in bridged mono.)

Insert the wire without the ridge or other marking into the Left

+

(positive) speaker

terminal on the A 21. (This is the negative speaker terminal in bridged mono.)

Insert the wire with the ridge or other marking into the red + (positive) terminal on the speaker.

Insert the wire without the ridge or other marking into the black -- (negative) terminal

on the speaker.

Do not make connections to either of the

A 21's black speaker terminals.