Philips SCD496 - Manual (Page 11)

Batteries contain substances that may pollute the environment. Do not throw away empty
batteries with the normal household waste, but hand them in at an official collection point.
Always remove the batteries before you discard or hand in the appliance at an official
collection point.
guarantee and service
If you need information or if you have a problem, please visit the Philips website at www.philips.com
or contact the Philips Customer Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local
Philips dealer or contact the Service Department of Philips Domestic appliances and Personal Care
BV.
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you cannot find the
answer to your question, contact the Customer Care Centre in your country.
Question Answer
Why don’t the ON light of
the baby unit and the
LINK light of the parent
unit light up when I press
the on/off buttons of the
units?
Perhaps the batteries of the parent unit are empty and the parent
unit is not connected to the mains. Replace the batteries or put the
small appliance plug in the parent unit and put the adapter in a wall
socket. Then press the on/off button to establish connection with the
baby unit.
Perhaps the batteries of the baby unit are empty and the baby unit is
not connected to the mains. Replace the batteries or put the large
appliance plug in the baby unit and put the adapter in a wall socket.
Then press the on/off button to establish connection with the
parent unit.
The baby unit and the parent unit may be out of range of each
other. Move the parent unit closer to the baby unit, but not closer
than 1 metre/3 feet.
If the LINK light on the parent unit still does not start to flash, use
the reset function to reset the units to their default settings.
Why does the parent unit
beep?
If the parent unit beeps while the LINK light flashes red, the
connection with the baby unit is lost. Move the parent unit closer to
the baby unit.
If the parent unit beeps and the battery check light is on, the
batteries are running low. Recharge the batteries.
Why does the appliance
produce a high-pitched
noise?
The units may be too close to each other. Make sure the parent unit
and the baby unit are at least 1 metre/3 feet away from each other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
Why don’t I hear a sound/
Why can’t I hear my baby
cry?
The volume of the parent unit may be set too low or may be
switched off. Increase the volume of the parent unit.
,
EngliSh 11