Belt clip, Connecting the belt clip, Disconnecting the belt clip – Philips SCD496 User Manual
Page 10: Reset function, Default settings, Cleaning and maintenance, Storage, Environment
The parent unit automatically resets to medium volume level and produces a paging alert
tone.
To stop the paging alert tone, press the PAGE button again briefly or press any button on the
parent unit.
Note: If you press the PAGE button too long, the parent unit does not produce the paging alert tone.
Belt clip
You can take the unit with you inside and outside the house if you attach the unit to your belt or
waistband with the belt clip. This allows you to monitor your baby while you are moving around.
Connecting the belt clip
1
Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Turn the belt clip to the left () until it locks into position (‘click’) (Fig. ).
Disconnecting the belt clip
1
Turn the belt clip to the right (1) and take it out of the opening () (Fig. ).
reset function
This function allows you to reset the parent unit and baby unit to the default settings. You can use
this function if problems occur that cannot be solved by following the suggestions in chapter
‘Frequently asked questions’. You have to reset each unit separately.
1
Press and hold the on/off button 3 for seconds to switch on the unit. (Fig. 11)
Then immediately press and hold the volume down (-) button until the appliance
beeps (Fig. ).
The unit has now been reset to the default factory settings.
Now do the same for the other unit.
Default settings
Parent unit
Loudspeaker volume: 1
Microphone sensitivity: 3
Baby unit
Loudspeaker volume: 3
Cleaning and maintenance
Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
Do not use a cleaning spray and/or liquid cleaners.
1
Unplug the baby unit and parent unit if they are connected to the mains.
Clean the parent unit and the baby unit with a damp cloth.
Storage
When you are not going to use the baby monitor for some time, remove the batteries and
store the parent unit, the baby unit and the adapters.
Environment
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 5).
,
,
-
-
-
,
,
EngliSh
10