PYLE Audio PQA3100 - Manual (Page 4)

Page5
Service
All the products are thoroughly examined and tested
before leaving the factory, and if used correctly will give you
many years of excellent service. However,
if a problem arises, proceed as follows:
(A) contact the retailer from whom the unit was purchased and
describe the symptoms of the fault.
(B) if the retailer cannot help, return the equipment to the
national distributor for your country. Use the original packaging
to protect the product from damage. Include a note with the
equipment stating your name and address, details of the
problems, date code and date and place of purchase.
FAULT PROBLEM SOLUTIONS
No sound
(power
LED off)
AC supply not connected or
switched off
Blown fuse
Check AC connections and switches
Check and replace fuses at plug and IEC
socket. USE ONLY SAME TYPE AND RATING!
NO sound
(Power
LED on)
No input,
or input too low
Level controls set too low
Speakers faulty or
not connected
Check input is connected, and LED
Increase level controls
Check speakers and speaker connections
Hum or
buzz is
audible
Noise from AC supply is being
picked up in the signal path
There is an earth problem
Use good quality, shielded signal cables and
ensure they are kept away from AC power cables
and other AC powered equipment
Use a mains tester to ensure the AC outlet
has a good earth. Power connected equipment(e.g mixer
and amp) from the same AC outlet where possible.
Distortion
is audible Excessive signal level
somewhere in signal chain.
Damaged or poor quality
cables
Sound cuts
out or is I
ntermittent
Damaged or poor quality
cables or connectors,
connectors not properly
inserted, amp overheating
Use only high quality cables of the appropriate type,
protect them from damage and regularly
check connections.
Use the LED to ensure the AC outlet has a good earth.
Power connected equipment from the same AC outlet
where possible
Check all cables and connections, refer to above
sections regarding distortion and temp warning light
PQA
www.pyleaudio.com