Polycom MITEL SX-200 - Manual (Page 12)

LinkPlus Interface Guide: Mitel SX-50, -200, -2000 System
PN: 1725-36137-001_E.doc 12
Hold
The Hold feature should be programmed to the Hold key as shown
on the key-map diagrams so that when the
Hold key or softkey is
pressed on the handset, the call is placed on hold.
Mute
The handset Mute function is hard-coded to FCN + 1 on the PTB4xx
handset. This function sequence is recommended, but the system
administrator can assign the Mute function to any available function
key sequence or leave the function unassigned. The SpectraLink 6000
and SpectraLink 8020/8030 Wireless Telephones use a
Mute softkey.
Voicemail
The message-waiting icon on the handset is activated with the
message indication of the deskset. The voicemail feature on the
deskset must be assigned to the feature key as shown in the key-map
diagrams. Do not assign any other feature to this key, since the
associated LED is directly mapped to the message-waiting icon on the
handset. This LED assignment must be used in order to support the
message-waiting icon. Using this key for any other feature or for line
access could cause unacceptable system performance.
Speakerphone
If a handset such as the PTB 4xx has no speaker, the Microphone,
Speaker, and Volume Up/Down buttons on the 420 have no
corresponding handset function.
Ring types
Handset ring types (soft, normal, vibrate, etc.) are programmed by the
handset user and are not accessible or changeable by the system
switch. Whenever possible the audible ringer on the handset will
follow the cadence provided by the system switch. Call progress tones
provided by the host system will be passed through to the handset.