Philips SC468 - Manual (Page 9)

ENGLISH 9
Problem solving
Problem Possible cause Solution
Power light does not Parent unit: unit is not turned on. Turn VOLUME ON/OFF control
light downwards.
Batteries are low. Recharge batteries.
Baby unit: unit is not turned on. Push power button.
Power adapter is not plugged in or Plug in power adapter or replace
batteries are exhausted. batteries.
High pitched noise Units are too close together. Move parent unit away from baby
unit.Turn VOLUME ON/OFF
control on parent unit upwards.
Parent Unit batteries Battery life is at an end. Connect charging base to mains,
do not charge power. Replace battery pack.
No sound Volume on Parent Unit is set too low. Turn VOLUME ON/OFF control
downwards.
Power light flashing Batteries are low or empty. Parent unit: - recharge battery pack.
Baby unit: - replace batteries or
connect to mains power.
Interference or poor Mobile or cordless phones too close. Move phones away from the units.
reception to the baby monitor.
Pick-up from another Both systems are operating on the Switch channels.
baby monitor same frequency.
System check light Units are out of range or there is Move units closer together to
flashing (green) / interference from another restore the link. Remove the other
System check alarm FM source. FM source.
Baby unit is not switched on. Push power button.
Hereby, Philips Consumer Electronics, B.U. Peripherals & Accessories,
declares that this SBC SC468 is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
XP SBC SC 468 book 18-09-2003 13:10 Pagina 9