Philips SBC SC 362 - Manual (Page 4)

4
SC362 page 4
CONTENTS
1. GENERAL .................................................4
2. QUICK REFERENCE .................................4
3. POWER SUPPLY ......................................4
4. OPERATION .............................................5
TECHNICAL SPECIFICATIONS..............24
ILLUSTRATIONS......................................3
INTRODUCTION
Congratulations! You have just purchased a
truly cordless Baby phone (SBC SC362) that
enables you to monitor your child from
wherever you are in and around your house.
The Baby phone has been tested to meet all
necessary regulations and standards, and
features a battery back-up option that
guarantees operation at all times.
Note: While the Baby phone is intended as an
aid, it is not a replacement for real parent
supervision and should not be used as such.
1. GENERAL
English
QUICK REFERENCE
1.Connect one of the enclosed mains adapters to the ‘baby unit’ and the
other to the ‘parent unit’ standing base (fig. 2).
2.Set the ‘baby unit’ to VOICE mode (fig. 1.4) and place it near the baby’s
bed.
3.Place the ‘parent unit’ in the standing base (fig. 2).
4.Switch the ‘parent unit’ to ON to an acceptable sound level (fig. 1.2).
– Every time sound is detected from or near the baby, it is transmitted to
the parent’s unit.
5.Adjust the sound level on the ‘parent unit’ as required.
3. POWER SUPPLY
2. QUICK REFERENCE
MAINS POWER SUPPLY
• Check that the mains voltage as indicated
on the mains adapter corresponds to your
local mains voltage. If it does not, consult
your dealer or our service organisation.
• Connect a mains adapter to the ‘baby unit’
as indicated in fig. 2 .
• Place the ‘parent unit’ inside the standing
base and connect a mains adapter as
indicated in
fig. 2 .
– If the mains power adapter is connected
correctly, the red ADAPTER LED on the
standing base lights up.
BATTERY POWER SUPPLY
(batteries not enclosed)
• Install batteries inside ‘baby unit’ as indicated
in fig. 3 for cordless ‘baby unit’ operation.
• Install batteries inside ‘parent unit’ as
indicated in fig. 3 for cordless ‘parent unit’
operation.
Notes
– Both the ‘baby unit’ and ‘parent unit’ have a
‘battery low’ indication. If the batteries are
low the unit beeps and the red POWER LED
starts flashing.
– Remove the batteries from the ‘ baby unit’
and the ‘parent unit’ when they are not
going to be used for a long period of time.
– To conserve batteries, connect the units to
the mains by using the enclosed mains
adapters.
– If batteries are installed and the mains
power adapters are connected, the units
operate on mains power. In the event of a
mains failure, the batteries will take over.
– Replace batteries with original PHILIPS LR6
POWERLIFE batteries only.