Patton electronic IM2RC/I-100B User Manual

Page 5

This device contains no user serviceable parts. This device can
only be repaired by qualified service personnel.

This device is NOT intended nor approved for connection to the
PSTN. It is intended only for connection to customer premise
equipment.

Electrostatic Discharge (ESD) can damage equipment and impair
electrical circuitry. It occurs when electronic printed circuit cards
are improperly handled and can result in complete or intermittent
failures. Do the following to prevent ESD:

• Always follow ESD prevention procedures when removing and

replacing cards.

• Wear an ESD-preventive wrist strap, ensuring that it makes

good skin contact. Connect the clip to an unpainted surface of
the chassis frame to safely channel unwanted ESD voltages
to ground.

• To properly guard against ESD damage and shocks, the wrist

strap and cord must operate effectively. If no wrist strap is
available, ground yourself by touching the metal part of the
chassis.

In accordance with the requirements of council direc-
tive 2002/96/EC on Waste of Electrical and Electronic
Equipment (WEEE), ensure that at end-of-life you sepa-
rate this product from other waste and scrap and deliver
to the WEEE collection system in your country for recy-
cling.

WARNING

CAUTION