Patton electronic IM2RC/I-100B - Manual (Page 13)

13
5.2 INSTALLING THE REAR IM2RC/I-100B CARD AND FRONT
FUNCTION CARD
The Model IM2RC/I-100B is a rear-mountable ethernet interface card
that works with Patton Models 3088RC and 2701RC access products.
The two cards meet inside the rack chassis and plug into each other by
way of mating 50 pin card edge connectors. Use the following steps as a
guideline for installing each Model IM2RC/I-100B and its function card
mate into the rack chassis:
1. Slide the IM2RC/I-100B rear card into the back of the chassis along
the metal rails provided.
2. Secure the IM2RC/I-100B rear card using the metal screws pro-
vided.
3. Slide the front function card into the front of the chassis. It should
meet the IM2RC/I-100B rear card when it is almost all the way into
the chassis.
4. Push the front card gently into the card-edge receptacle of the rear
card. It should “click” into place.
5. Secure the front card using the thumb screws.
The IM2RC/I-100B card contains sensitive integrated
circuitry. Failure to ground yourself during installation
may result in damage to the IM2RC/I-100B-100B card or
the front function card.
CAUTION