Philips CED1700 User Manual
Page 9
9
English
2
Connect the other end of the supplied standard connector to
the car audio system.
Caution
In order to avoid any accident, the driver must not watch video while driving. This
unit is designed to not allow watching moving video while driving. Park your car in a
safe place and engage the parking brake before watching moving video.
Note
The video blocking system under parking brake not engaged only control this unit’s
display, and will not affect the video output through the rear RCA video output.
If watch moving video from Disc or AV-In source but parking brake is not properly
connected, the video signal will be blocked by the system, and the below display
will be shown on TFT:
Connect wires
Caution
Ensure that all loose leads are insulated with electrical tape.
1
Check the car’s wiring carefully, then connect them to the
supplied ISO wires.
Connector
Connect to
1
Yellow wire
The +12V car battery which is live at all
times.
2
Blue wire
The electric antenna control lead
or power supply lead of the antenna
booster
If there is no electric antenna or antenna
booster, or it is manually operated
telescopic antenna, it is not necessary to
connect this lead.
3
Black wire
A metal surface of the car
First connect the black ground (earth)
lead, then connect the yellow and red
power supply leads.
4
Red wire
The +12V power terminal which is live
in the accessory (ACC) position of the
ignition switch
If there is no accessory position, connect
to the +12V car battery terminal that is
always live. Be sure to connect the black
ground (earth) lead to a metal surface of
WKH FDU ÀUVW
5
Green and green/
black wires
Left speaker (Rear)
6
White and white/
black wires
Left speaker (Front)
7
Gray and
gray/black
wires
Right speaker (Front)
8
Purple and purple/
black wires
Right speaker (Rear)
EN