Philips CED1700 User Manual
Page 11
11
English
Note
Please consult your Phillips dealer or distributer to purchase the CEA100 external
navigation box.
Mount in the dashboard
Note
Check wire connection before you mount the unit into a car.
If preset radio stations are lost when the ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to the yellow ones.
1
If the car does not have an on-board drive or navigation
computer, disconnect the negative terminal of the car battery.
If you disconnect the car battery in a car that has an on-
board drive or navigation computer, the computer may lost
its memory.
If the car battery is not disconnected, to avoid short-circuit,
ensure that bare wires do not touch each other.
2
Ensure that car dashboard opening is within these
measurements:
CEA100
182 mm
112mm
5mm
Connector/Obeject
Connect to/with
1
Pink wire
Extension wire
2
2.5m extension wire
(Not included)
Parking brake (-)
3
Brake switch
4
Ground
5
ISO wires
Connected in step 1 above.
6
Grey wire
Rear line out Left/Right
7
Black wire
Front line out Left/Right
8
Blue cable
Subwoofer
9
Red cable
Aux Right
10
White cable
Aux Left
11
Yellow cable
Video in
12
Yellow cable
Camera in
13
Yellow cable
Video out 1
14
Yellow cable
Video out 2
15
Purple wire
Reverse camera (B+)
16
Gearbox switch
17
Reverse gear signal
Back lamp lead +
Connect radio antenna
Connect the radio antenna to the radio antenna of the system for
better radio signal.
1
Connect the radio antenna to the car antenna.
Connect external navigation box
This unit supports GPS navigation by connecting Philips CEA100
external GPS navigation box.
EN