Philips DVDR3537 - Manual (Page 9)

9 EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
Others
9 EN
FUNCTIONAL OVERVIEW
(*) The unit can also be turned on by pressing these buttons.
1. STANDBY-ON button
Press to turn the unit on and off.
If timer programmings have been set, press to set the
unit in timer-standby mode.
2. Disc tray
Place a disc when opening the disc tray.
3. OPEN/CLOSE A button*
Press to open or close the disc tray.
4. Display
Refer to “Front Panel Display” on page 12.
5. RECORDING indicator
Lights up when recording function works.
6. PLAY B button*
Press to start or resume playback.
7. STOP C button
Press to stop playback or recording.
8. RECORD button
Press once to start a recording. Press repeatedly to
start one-touch timer recording.
9. DV-IN jack (E3)
Use to connect the DV output of external device with
a DV cable.
10. AUDIO input jacks (E2)
Use to connect external device with a RCA audio
cable.
11. VIDEO input jack (E2)
Use to connect external device with a RCA video
cable.
12. S-VIDEO input jack (E2)
Use to connect the S-video output of external device
with an S-video cable.
13. Infrared sensor window
Receive signals from your remote control so that you
can control the unit from a distance.
1 2 3* 5 6* 7 8
9 10 11 12 13
4
IN
IN OUT OUT
VIDEO OUT Y
P R /C R
P B /C B
R
L
R
L
VIDEO
IN
S-VIDEO S-VIDEO ANTENNA
COAXIAL
HDMI OUT
AV IN AV OUT COMPONENT VIDEO OUTPUT DIGITAL AUDIO OUTPUT PCM / BITSTREAM
1 2 4 3 6 5
10 8 7 12 11 9
1. ANTENNA IN jack
Use to connect an antenna.
2. VIDEO IN jack (E1)
Use to connect external device with a RCA video
cable.
3. VIDEO OUT jack
Use to connect a TV monitor, AV receiver or other
device with a RCA video cable.
4. COMPONENT VIDEO OUTPUT jacks
Use to connect a TV monitor with component video
inputs with a component video cable.
5. HDMI OUT jack
Use an HDMI cable to connect to a display with an
HDMI compatible port.
6. AC Power Cord
Connect to a standard AC outlet to supply power to
this unit.
7. COAXIAL DIGITAL AUDIO OUTPUT jack
Use to connect an AV receiver, Dolby Digital decoder
or other device with a digital audio coaxial input jack
with a digital audio coaxial cable.
8. S-VIDEO OUT jack
Use to connect the S-video input of a TV monitor, AV
receiver or other device with an S-video cable.
9. AV OUT jacks
Use to connect a TV monitor, AV receiver or other
device with a RCA audio cable.
10. S-VIDEO IN jack (E1)
Use to connect the S-video output of external device
with an S-video cable.
11. AV IN jacks (E1)
Use to connect external device with a RCA audio
cable.
12. ANTENNA OUT jack
Use to connect an RF coaxial cable to pass the signal
from the ANTENNA IN to your TV.
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
Front Panel
Rear Panel
E7H42UD_DVDR3506-37_EN.indd 9 E7H42UD_DVDR3506-37_EN.indd 9 2007/12/28 10:52:45 2007/12/28 10:52:45