Paxar Monarch TC6039SA - Manual (Page 16)

3-2 System Administrator’s Guide
Finding a Network
The printer searches for available networks and lists the SSIDs, signal
strength, and encryption for each network. You can connect to an existing
network profile if you have the required network security information.
1. Tap , Find WLANs.
The printer searches for all networks in range and lists them
alphabetically by SSID. This may take a few minutes.
Note: A key indicates that encryption is enabled on the access point. You
must have the network encryption settings to connect to a protected
access point.
2. Select a network and tap Connect.
The Profile Configuration screen appears.
3. Verify the mode, authentication, encryption, and IP configuration
settings.
4. Tap OK when you are finished.