Polk Audio LC265i-IP EN - Manual

w w w . P o l k A u d i o . c o m / 8 0 0 . 3 7 7 . 7 6 5 5 ( U S A & C a n a d a ) / 4 1 0 . 3 5 8 . 3 6 0 0 ( W o r l d w i d e ) 1
LC265i-IP Hardware (included)
• One LC265i-IP speaker
• Performance Optimization Wizard – CD-ROM
• Euro-style (Phoenix) power supply connector
• Mounting template
• Paint mask
• Weather-resistant aluminum grille
and stainless steel hardware
• LCi-IP manual
• Laminated configuration setup card
• Registration card
Note: If you are setting up LCi-IP speakers to be controlled via an
IP-network such as NetStreams
™ Digilinx ™ , purchase a network card, which
is sold separately, from NewStreams ™ . The network card will control up to
one pair of speakers.
Important Note: If anything is missing or damaged, or if your LCi-IP speaker
fails to operate, notify Polk Audio Installer Support Services immediately at
800-377-7655. Hours: Mon-Fri, 9am - 5:30pm EST.
Accessories (not included)
• Performance Enclosure for exact volume enclosure performance
in pre-build installations. Improves bass performance and
sound isolation. Model number: ENCL265.
• Speaker-level-to-line-level transformer, such as the PAC SNI-35.
(For analog installations only. Powers up to 2 each LC265i-IP speakers.)
• SPS-1 Power Supply (a power supply is required).
THIS DOCUMENT APPLIES TO LC265i-IP AND LC80i-IP PRODUCTS
Cutsheet for LC265i-IP/LC80i-IP
World’s First Active High Performance IP Addressable Loudspeakers
Polk Audio LCi-IP Ultra High Performance In-Wall/ In-Ceiling Loudspeakers are the world’s first active Internet Protocol-ready Loud-
speakers. They were created for IP networked systems (such as the ground-breaking NetStreams
™ DigiLinx ™ system). Integrated digital
amplifiers eliminate remote amplifiers connected via hundreds of feet of performance-robbing speaker wires. The built-in Digital
Signal Processor (DSP) and supplied Room Correction Software (the Performance Optimization Wizard
™ ) enable every LCi-IP speaker
to be optimized for maximum performance in any room. While the LCi-IP Series provides the greatest functionality when used
within an IP-based system, these speakers are also compatible with any analog distributed audio system.
Cutout
Dimension
19 1/4"
(48.9 cm)
Cutout
Dimension
7 1/4"
(18.4 cm)
Total
Depth
3 9/16"
(9.1 cm)
LC265i-IP Dimensions
Overall Height 20 7/8" (55.5cm)
Overall Width 8 1/2" (30.4cm)
Available Finish: Paintable White
LC265i-IP Performance Enclosure Dimensions
55 5/8" H x 14" W x 3 3/8" D (141.3cm x 35.6cm x 8.6cm)