Philips DVD Micro Theatre MCD702 - Manual (Page 17)

17
English
Step 1: Inserting batteries into
the Remote Control
1
3
2
1
Open the battery compartment.
2
Insert two AAA batteries following the
indications (+/-) inside the compartment.
3
Close the cover.
Using the Remote Control to operate
the Player
1
Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.
2
Do not put any objects
between the Remote Control
and the DVD Player while
operating the DVD Player.
CAUTION!
–
Remove batteries if they
are exhausted or if the Remote Control
is not being used for a long time.
–
Do not use old and new or different
types of batteries in combination.
–
Batteries contain chemical substances,
so they should be disposed of properly.
Step 2: Setting up the TV
IMPORTANT!
–
Make sure you have completed all the
necessary connections. (See
“Connecting TV”).
–
In order for a DVD disc to play on this
Player, the colour system of the Disc, the
TV and the DVD Player should match.
1
Switch the DVD system on and then select
DISC source. (See “Switching the system
on/off”).
2
Turn on the TV and set to the correct video-in
channel. You should see the blue Philips DVD
background screen on the TV.
➜
Usually these channels are between the
lowest and highest channels and may be called
FRONT, A/V IN, or VIDEO. See your TV manual
for more details.
➜ Or, you may go to channel 1 on your TV, then
press the Channel down button repeatedly until
you see the Video In channel.
➜
Or, the TV Remote Control may have a
button or switch that chooses different video
modes.
➜
Or, set the TV to channel 3 or 4 if you are
using an RF modulator.
Getting Started
STANDBY-ON
IR SENSOR
pg001-036_MCD700_37_Eng 2005.7.7, 13:22 17