Pioneer A-A9-J - Manual (Page 16)

Other connections 05
16
En
Operating other Pioneer
components with this unit’s
sensor
Many Pioneer components have SR CONTROL
jacks which can be used to link components
together so that you can use just the remote
sensor of one component. When you use a
remote control, the control signal is passed
along the chain to the appropriate component.
• Note that if you use this feature, make sure
that you also have at least one set of analog
audio jacks connected to another
component for grounding purposes.
1 Connect the CONTROL OUT of this
amplifier to the CONTROL IN jack of another
Pioneer component.
Use a cable with a mono mini-plug on each
end for the connection.
2 If the Pioneer component also has a
CONTROL OUT jack, you can continue the
chain in the same way for as many
components as you have.
GND
L
SIGNAL
CONTROL
OUT
IN
CONTROL
OUT
Pioneer component
Pioneer
component
remote
control
This amplifier
A9_MY.book Page 16 Tuesday, October 10, 2006 10:40 AM